Risk Stewards: Supply and Borrow Cap Changes on Aave V3 /
Summary LlamaRisk recommends the following parameter changes based on user behavior, on-chain liquidity, and position health observed in the latest review of Aave V3 reserves. Aave V3 Core: Increase supply cap for BTC.b from 20 to 40. Aave V3 Mantle: Increase supply cap for USDe from 10,000,000 to 20,000,000. Increase borrow cap for USDe from 9,000,000 to 18,000,000. Aave V3 Base: Increase supply cap for cbETH from 50,000 to 75,000. Aave V3 Monad: Increase supply cap for USDe from 20,000,000 to 40,000,000. Increase borrow cap for USDe from 18,000,000 to 36,000,000. Increase supply cap for sUSD
TL;DR
On July 30, 2026 Aave increased the core GHO borrow rate to 5% and raised Prime market rates as its USDC stability module emptied. The move aligns borrowing costs with savings yields, aims to protect the $1 peg, and reflects broader supply‑side risk concerns in DeFi.
Key facts
- Aave’s core GHO borrow rate was raised to 5% on July 30, 2026.
- The Prime market base rate increased to 3.00% with a kink rate of 4.25%.
- The USDC stability module was reported as nearly empty at the time of the change.
- GHO traded near $0.999 during September and early October 2026.
- Monad early investors hold about 19.7 billion MON, roughly 20% of supply.
- Ledger devices sold through CryptoBilis were found with unauthorized implants.
On July 30, 2026 the Aave V3 Risk Council lifted the core GHO borrow rate on Ethereum to 5%, up from the 4.25%‑4.50% range proposed earlier in the month. The same council also nudged the Prime market base rate to 3.00% and raised its kink rate to 4.25%. The move came as the USDC stability module emptied, the USDT module held roughly 22.5 million USDT, and GHO traded just under its $1 peg. The adjustment aims to curb cheap borrowing that was fueling a supply‑side imbalance in the over‑collateralised stablecoin.
Background
Aave’s GHO is an over‑collateralised stablecoin that relies on a mix of collateral, interest rates and arbitrage tools called Stability Modules (GSMs) to stay near its $1 target. When GHO trades below the peg, arbitrageurs can buy it cheap and redeem it for USDC or USDT through the GSMs, pulling the price back up but also draining the stablecoin reserves. By September‑October 2026 the USDC module was nearly empty while the USDT module retained about 22.5 million USDT, leaving the peg vulnerable. At the same time, broader financial markets saw Basel III capital ratios for large banks remain stable, with Tier 1 capital impacts at +2.2% as of December 2025, indicating a relatively steady macro backdrop. In the crypto ecosystem, supply‑side risks were also evident: Monad’s early investors held roughly 19.7 billion MON – about 20% of total supply – and rejected a $60 million liquidity program, keeping a large locked supply in play ahead of November unlocks. Hardware‑wallet supply‑chain concerns resurfaced after Ledger devices sold through CryptoBilis were found with unauthorized implants that could exfiltrate recovery phrases, underscoring the importance of trustworthy intermediaries in crypto infrastructure.
What happened
The Aave GHO Risk Council acted on October 2, 2026, when TokenLogic, a GHO steward, submitted a proposal to raise the core borrow rate on Ethereum from 4.25% to 4.50% APR. The council later implemented a higher figure, with The Defiant reporting the new core rate at 5%, a level above the proposal. Simultaneously, the council increased the Prime market base rate from 2.75% to 3.00% and lifted the kink rate to 4.25%, preserving a 25‑basis‑point discount for optimal utilisation. These changes were executed via the updateGhoBorrowRate function, which respects preset per‑update limits, allowing swift adjustments without a full governance vote. The rationale, as outlined in the October proposal, was to align borrowing costs with the Aave Savings Rate, which sat at 4.50%, thereby eliminating a 25‑basis‑point “free lunch” where users could borrow cheap GHO and earn a higher return by staking it as sGHO. The rate hikes also respond to the depletion of the USDC stability module, which had been a primary tool for maintaining the peg, and the modest USDT reserve of about 22.5 million USDT. By making borrowing more expensive, the council hopes to encourage repayment, reduce GHO supply pressure, and replenish the GSMs. The move marks the third rate adjustment in as many months, following an August increase from 3.75% to 4.25% and a September tweak, signalling a pattern of proactive risk stewardship by Aave’s governance bodies.
Market impact
The core GHO borrow rate now sits at 5%, up from the 4.25%‑4.50% range that was being discussed earlier in October. The Prime market base rate has risen to 3.00% with its kink rate at 4.25%, still offering a 25‑basis‑point discount at optimal utilisation. The USDC stability module was reported as “nearly empty” when the rate change landed, while the USDT module retained roughly 22.5 million USDT. GHO’s market price hovered at $0.999 throughout September and early October, reflecting the pressure on the peg. Borrowers now face higher costs, which should incentivise repayment and potentially drive buying pressure on GHO in the open market. The higher rates also narrow the arbitrage gap that previously allowed users to mint cheap GHO, stake it for a 4.50% yield, and pocket the spread. In parallel, Monad’s price remained below $0.025, with key support at $0.019‑$0.020 and resistance near $0.021‑$0.022, while early investors held about 19.7 billion MON, roughly 20% of supply, after rejecting a $60 million liquidity program. Ledger’s supply‑chain breach highlighted that even authorized resellers can introduce hardware implants, adding another layer of risk to crypto asset custody.
Why it matters
Aave’s rate adjustments directly influence the economics of GHO, a stablecoin that underpins many DeFi lending and borrowing activities. By raising the borrow cost to match the savings yield, the protocol removes an incentive for users to mint GHO solely to capture a risk‑free spread, thereby protecting the peg and the stability modules from excessive outflows. The depletion of the USDC module and the modest USDT reserve mean that any further price deviation could strain the system’s ability to redeem GHO at $1, making the higher rates a defensive tool. For borrowers, the increased cost reduces leverage opportunities and may shift demand toward alternative stablecoins. For lenders, the alignment of rates could improve confidence in GHO’s long‑term viability. The broader context—stable Basel III capital ratios for banks, supply‑side pressure from Monad’s locked tokens, and hardware‑wallet supply‑chain attacks—highlights that risk stewardship is a multi‑layered challenge across traditional finance, DeFi protocols, and crypto infrastructure. Aave’s swift, limited‑scope rate changes illustrate how protocol‑level governance can act as a first line of defence against systemic stress.
DeFi Intel’s take
Editorial analysis, not a statement of fact.
DeFi Intel's take: the Aave Risk Council’s decision to push the core GHO borrow rate to 5% signals a clear intent to tighten monetary policy within the protocol. We read this as an effort to close the borrowing‑savings spread that was creating a low‑risk arbitrage loop, thereby reinforcing the peg at a time when the USDC stability module is effectively dry. The pattern of monthly rate tweaks suggests the council is monitoring liquidity metrics closely and is prepared to act incrementally rather than waiting for a larger shock. While the higher cost may dampen borrowing demand, it also helps refill the GSMs, which are essential for price stability. In a broader sense, the move aligns with a growing emphasis on supply‑side risk management across the crypto ecosystem, from Monad’s locked MON supply to Ledger’s hardware‑wallet supply‑chain concerns. Together, these signals point to a maturing risk‑management culture that balances user incentives with systemic resilience.
Sources used for this analysis
- bis.org/media-releases/20260923-basel-iii-risk-based-capital-and-leverage-ratios-are-stabl
- ambcrypto.com/monad-cryptos-60m-liquidity-program-ends-is-mons-supply-risk-rising/
- cointelegraph.com/news/hardware-wallet-supply-chain-risk-ledger-incident
- cryptobriefing.com/aave-raises-gho-borrow-rate-reserves/
DeFi Intel wrote this analysis from the reporting above. Any figure or quotation can be checked against those pages.
Frequently asked questions
Why did Aave raise the GHO borrow rate to 5%?
Aave raised the core GHO borrow rate to 5% to align borrowing costs with the 4.50% Aave Savings Rate, eliminating a cheap‑borrow, higher‑yield arbitrage. The higher rate also aims to reduce borrowing pressure on the depleted USDC stability module and encourage repayments that can refill the GSMs, supporting the $1 peg.
What is the status of the USDC and USDT stability modules?
When the rate change was implemented, the USDC stability module was reported as nearly empty, while the USDT module held about 22.5 million USDT. These reserves are used to redeem GHO at near‑par value, so their depletion raises concerns about maintaining the peg.
How does the Monad liquidity program affect MON’s supply risk?
Monad’s $60 million liquidity program was closed after early investors, who hold roughly 19.7 billion MON (about 20% of total supply), rejected the offers and chose to HODL. This leaves a large locked supply in place ahead of the November unlocks, keeping potential selling pressure high despite the program’s closure.
DeFi Intel is an entity-graph aggregator: we curate, tag and link crypto news to a typed knowledge graph of protocols, tokens, people and incidents. We do not republish the full article body. Use the link above to read the original report at Aave_blog.
Entities in this story
Discussion
Comments are reviewed before publication.
Want the full article?
Continue reading on Aave_blog →
No comments yet.